*TunerStudioのポート名とMicrosquirt(DIY-PNP CPU)との対応 [#i3e388b8]
-タコ出力はD14 (DIYAUTOTUNE 配布の初期ファイルだと競合する)
-MSTuner の Project設定で 使用モジュール設定をMicrosquirt Moduleにしておけばピン名との整合がとれる
| Microsquirt module J2 header |The main 50 pin header connector is J2:1,2: +12V fused power input&br;3: 0-5V MAP sensor input&br;4: Serial RX comms to tuning computer &br;5: Coolant temperature sensor&br;6: Serial TX comms to tuning computer &br;7: Accel LED "D16" mid current ground out, SparkD&br;8: Bootload, the "boot jumper" rarely used&br;9: Manifold Air Temp sensor&br;10: CAN communications H&br;11: Warmup LED "&color(#ff0000){''D15''};" mid current ground out, SparkC&br;12: CAN communications L&br;13: 0-5V Throttle position sensor input&br;14: VR tach signal no.2 (+) input&br;15: 5V vref out (for TPS)&br;16: SpareADC2 0-5V analogue input or digital output&br;17: SpareADC1 0-5V analogue input or digital output&br;18: 0-5V Flex fuel input&br;19: Opto tacho in(+)&br;20: FIDLE mid current ground out&br;21: Opto tacho in(-)&br;22: Fuel Pump mid current ground out&br;23: VR tach signal no.1 (+) input&br;24,26,28,30,32: INJ1 out. Use all the INJ1 pins in parallel&br;25: VR1,2 GND&br;27: 0-5V Oxygen sensor input&br;29: Tach "''&color(#ff0000){D14};''" low current ground out&br;31: Serial GND&br;33: Sensor GND&br;34,36,38,40,42: INJ2 out. Use all the INJ2 pins in parallel&br;35,37,49,41,42,43,45,47,49: Power GND. Use all Power Grounds in parallel&br;44: IGN2 low current output, SparkB&br;46: IGN2 out&br;48: IGN1 low current output, SparkA&br;50: IGN1 out|
| Microsquirt module J1 header |The secondary 10 pin header is J1:1: PA0 Generic output (raw CPU pin)&br;2: PE1 Input only Tableswitching (raw CPU pin)&br;3,5: GND&br;4: ALT_INJ1, digital injector 1 signal&br;6: ALT_INJ2, digital injector 2 signal&br;7: PT7 Stepper idle channel (IAC) or additional injector&br;8: ALT_CAM zero crossing setpoint for VR2&br;9: PT6 Stepper idle channel (IAC) or additional injector&br;10: IACEnbl Stepper idle chip enable|
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
