TunerStudioのポート名とMicrosquirt(DIY-PNP CPU)との対応 †
- タコ出力はD14 (DIYAUTOTUNE 配布の初期ファイルだと競合する)
- MSTuner の Project設定で 使用モジュール設定をMicrosquirt Moduleにしておけばピン名との整合がとれる
| Microsquirt module J2 header | The main 50 pin header connector is J2:1,2: +12V fused power input
3: 0-5V MAP sensor input
4: Serial RX comms to tuning computer
5: Coolant temperature sensor
6: Serial TX comms to tuning computer
7: Accel LED "D16" mid current ground out, SparkD
8: Bootload, the "boot jumper" rarely used
9: Manifold Air Temp sensor
10: CAN communications H
11: Warmup LED "D15" mid current ground out, SparkC
12: CAN communications L
13: 0-5V Throttle position sensor input
14: VR tach signal no.2 (+) input
15: 5V vref out (for TPS)
16: SpareADC2 0-5V analogue input or digital output
17: SpareADC1 0-5V analogue input or digital output
18: 0-5V Flex fuel input
19: Opto tacho in(+)
20: FIDLE mid current ground out
21: Opto tacho in(-)
22: Fuel Pump mid current ground out
23: VR tach signal no.1 (+) input
24,26,28,30,32: INJ1 out. Use all the INJ1 pins in parallel
25: VR1,2 GND
27: 0-5V Oxygen sensor input
29: Tach "D14" low current ground out
31: Serial GND
33: Sensor GND
34,36,38,40,42: INJ2 out. Use all the INJ2 pins in parallel
35,37,49,41,42,43,45,47,49: Power GND. Use all Power Grounds in parallel
44: IGN2 low current output, SparkB
46: IGN2 out
48: IGN1 low current output, SparkA
50: IGN1 out | | Microsquirt module J1 header | The secondary 10 pin header is J1:1: PA0 Generic output (raw CPU pin)
2: PE1 Input only Tableswitching (raw CPU pin)
3,5: GND
4: ALT_INJ1, digital injector 1 signal
6: ALT_INJ2, digital injector 2 signal
7: PT7 Stepper idle channel (IAC) or additional injector
8: ALT_CAM zero crossing setpoint for VR2
9: PT6 Stepper idle channel (IAC) or additional injector
10: IACEnbl Stepper idle chip enable |
|
![[PukiWiki]](image/pukiwiki.png "[PukiWiki]")
